banner

News

How to Replace a Front Brake Hose

Update:30-10-2017
Summary:

There are several reasons why the front brake hose is r […]

There are several reasons why the front brake hose is replaced, the most common being the leak. This problem may cause the brake to malfunction because it is a front brake hose that provides fluid. It runs from your brake master cylinder to the front brake calipers, and when the brake calipers do not have the required amount of brake fluid, they do not depress the brake pads on the rotor and stop the vehicle. Fortunately, replacing the vehicle's front brake hose is not a daunting task. However, you must follow some very important steps to ensure your vehicle is safe.

The first thing you need to do is repair your vehicle and remove the tires. Make sure your receptacle is placed in a safe area so that the vehicle does not fall; this is a very important safety measure. Next, place the container under the front brake hose. This will absorb the brake fluid in the hose so that you can handle it properly.

Before you can wear a new front brake hose, you must remove the old brake hose. To do this, pick up your wrench and loosen the hose connector in the master cylinder. After that, remove the fittings on the brake caliper. Then you need a screwdriver to hold the hose clamp in place.

The last most important step in maintenance is to discharge the brakes, which remove all the air from the new hose. If you do not do so, the air in the line will interfere with the normal operation of the brakes.

Fill the brake fluid reservoir. Then, close to the caliper, let the car staff three times the bicycle three times, and keep it in the third position. While holding the pedal, you need to retract the nut and caliper. Do this process several times until all the air is out. Then, replace the wheel, remove the vehicle from the jack, and test your service in a safe area.